Accessory only
Payload supply, with compatibility and package contents confirmed by quotation.
Back to equipment & accessories
LiDAR mapping
DJI Zenmuse L3
An aerial LiDAR and RGB payload for terrain capture, vegetation surveys and infrastructure mapping.
Aircraft compatibility
Matrice 400 only. Requires the dedicated Zenmuse L3 single gimbal connector and compatible aircraft, controller and payload firmware.
Application & training
Plan a suitable LiDAR capture, check positioning and calibration, then review the data and processing workflow in DJI Terra. Software, control and quality checks are scoped to the job; no survey accuracy is guaranteed by purchase.
Choose your support
Accessory + handover
Mounting, firmware checks, setup and equipment familiarisation.
Accessory + application training
Practical capture planning and a workflow session scoped to your team and application.
Training scope, prerequisites, location, dates, duration and price are confirmed by quotation. Enquiring does not reserve a course place or grant a licence.
Key specifications
- LiDAR wavelength
- 1535 nm
- RGB mapping
- Two 100 MP cameras with 4/3-inch sensors
- Laser pulse settings
- 100, 350, 1000 or 2000 kHz; flight-height and return settings vary
- Returns
- Up to 16 at 100 or 350 kHz
- Weight
- 1.60 kg, excluding the dedicated gimbal connector
- Dimensions
- 192 × 162 × 202 mm
- Power
- 64 W typical; 100 W maximum
- Operating temperature
- −20 to 50°C
- Protection
- IP54 under manufacturer test conditions; protection can reduce with wear
Manufacturer specification snapshot checked 27 October 2026. Performance depends on conditions and configuration. Full DJI specifications and test conditions.